NTP Based Backdoor For Red Team Engagements In Hardened Networks

Sandman is a backdoor that is meant to work on hardened networks during red team engagements.

Sandman works as a stager and leverages NTP (a protocol to sync time & date) to get and run an arbitrary shellcode from a pre-defined server.

Since NTP is a protocol that is overlooked by many defenders resulting in wide network accessibility.

python3 sandman_server.py "Network Adapter" "Payload Url" "optional: ip to spoof"

• Network Adapter: The adapter that you want the server to listen on (for example Ethernet for Windows, eth0 for *nix).

• Payload Url: The URL to your shellcode, it could be your agent (for example, CobaltStrike or meterpreter) or another stager.

• IP to Spoof: If you want to spoof a legitimate IP address (for example, time.microsoft.com’s IP address).

SandmanBackdoor (Usage)

To start, you can compile the SandmanBackdoor as mentioned below, because it is a single lightweight C# executable you can execute it via ExecuteAssembly, run it as an NTP provider or just execute/inject it.

SandmanBackdoorTimeProvider (Usage)

To use it, you will need to follow simple steps:

• Add the following registry value:

reg add "HKEY_LOCAL_MACHINESYSTEMCurrentControlSetServicesW32TimeTimeProvidersNtpClient" /v DllName /t REG_SZ /d "C:PathToTheDll.dll"

• Restart the w32time service:

sc stop w32time
sc start w32time

NOTE: Make sure you are compiling with the x64 option and not any CPU option!

Capabilities

• Getting and executing an arbitrary payload from an attacker’s controlled server.

• Can work on hardened networks since NTP is usually allowed in FW.

• Impersonating a legitimate NTP server via IP spoofing.

Setup

SandmanServer (Setup)

SandmanBackdoor (Setup)

To compile the backdoor I used Visual Studio 2022, but as mentioned in the usage section it can be compiled with both VS2022 and CSC. You can compile it either using the USE_SHELLCODE and use Orca’s shellcode or without USE_SHELLCODE to use WebClient.

SandmanBackdoorTimeProvider (Setup)

To compile the backdoor I used Visual Studio 2022, you will also need to install DllExport (via Nuget or any other way) to compile it. You can compile it either using the USE_SHELLCODE and use Orca’s shellcode or without USE_SHELLCODE to use WebClient.

IOCs

Contributes

Thanks to those who already contributed and I’ll happily accept contributions, make a pull request and I will review it!